plumbing - How can I add valves to supply lines when the lines are soldered to the faucet? - Home Improvement Stack Exchange

I am trying to replace an old faucet that my 3 yo child is unable to use because of its design. I'm new to plumbing but actively reading. I haven't seen these supply lines w/o valves before. This l

plumbing - Why are there loops of copper water pipe coming out of my concrete floor? - Home Improvement Stack Exchange

Dishwasher not filling after replacing sink faucet - Home Improvement Stack Exchange

freezing - Is this a frost free outdoor faucet? - Home Improvement Stack Exchange

plumbing - What is this copper ring insert in my sharkbite supply valve? - Home Improvement Stack Exchange

plumbing - What is this spigot shutoff valve called? - Home Improvement Stack Exchange

plumbing « Home Improvement Stack Exchange Blog

Plumbing « Home Improvement Stack Exchange Blog

plumbing - Stubbing NPT shower valve to PEX, thread or solder first? - Home Improvement Stack Exchange

safety - Do water lines that contain lead need to be replaced if it doesn't flow out of a valve that I normally drink out of? - Home Improvement Stack Exchange

plumbing - Can I use these old supply valves under my kitchen sink to install a new modern faucet? - Home Improvement Stack Exchange

plumbing - How do I remove this fastener under my bathroom faucet - Home Improvement Stack Exchange

plumbing - How can I fasten nuts in narrow places when installing a faucet? - Home Improvement Stack Exchange